Sponsored by:
ACM/SIGDA IEEE CAS
IEEE
CEDA
IEICE IPSJ

Preparation Guide for Technical Paper Submission

Deadline

Deadline for submission: 5 PM AOE (Anywhere on Earth), July 6 (Fri), 2018

Key Dates:

  • Deadline for submission: 5 PM AOE (Anywhere on Earth) July 6 (Fri.), 2018
  • Notification of acceptance: Sep. 10 (Mon.), 2018
  • Deadline for final version: 5 PM AOE (Anywhere on Earth) Nov. 5 (Mon.), 2018

Instructions

In order to submit your paper, please follow the instructions below.

1) Paper preparation

  • Initial manuscripts should NOT include authors' names and their affiliations in order to perform a blind review. Authors' names, their affiliations and the contact person are requested when you submit your paper via the paper submission system.

  • The paper should be 6 pages in length including all figures, tables and references. The technical expositions will be reviewed by specialists but should include an introduction for nonspecialists that describes the problem and achieved results, focusing on the important ideas and their significance.

  • Accepted file format is PDF only. No other formats will be accepted. You must make a pdf file which can be read by Acrobat Reader 5.0. Manuscripts should not include special fonts such as Asian fonts.

  • The paper for initial submission is to be formatted like this (LaTex, LaTex2e). You can get the templates of initial submission for (LaTex), (LaTex2e), and (MSWord).

2) Paper Submission

Requirement

  • All accepted papers should be presented by one of the authors at the conference.
  • Double and/or parallel submissions of similar work to any other conferences, symposia, and journals are not allowed.
  • It is mandatory that at least one co-author per accepted paper registers the conference at the speaker's registration rate.
    Please note that each paper shall be accompanied by at least one different full conference registration at the speaker rate (i.e., two speaker's registrations are needed for two accepted papers, e.g. from the main author or a co-author of a paper).

Remarks:

  • Papers will be accepted for publication as either of regular papers or short papers. The paper type ** cannot ** be chosen by authors when submitting papers.
  • Papers may need to be shortened after acceptance, depending on the paper type. The page limit for short papers will be four.
  • The page limit for regular papers is 6 pages. For the camera-ready version up to 2 extra pages (maximum 8 pages) are allowed with extra payment.
  • Any modification in authors' names including the order of the listed authors after submission deadline is not allowed except that TPC approves the modification.


Inquiry

For more information, please contact: aspdac2019-tpc [at] mls.aspdac.com

Last Updated on: May 17, 2018