Preparation Guide for University LSI Design Contest

Deadline

Deadline for submission: 5 PM AOE (Anywhere on Earth) Aug. 8 (Fri), 2025

In order to submit your paper, please follow the instructions below.

1) Paper preparation

Initial manuscripts may include authors' names and their affiliations. Authors' names, their affiliations and the contact person are requested when you submit your paper on the the web page for paper submission.

The paper should be within 2-4 pages in length including all figures, tables and references. The technical expositions will be reviewed by specialists but should include an introduction for nonspecialists that describes the problem and achieved results, focusing on the important ideas and their significance.

Accepted file format is PDF only. No other formats will be accepted. Manuscripts should not include special fonts such as Asian fonts.

The initial submission must be formatted in the IEEE style template. Its templates are:

IEEE Templates	PDF Files
LaTeX conference mode (Original Sources)	sample-Latex.pdf
MS-Word US letter (Original Sources)	sample-Word.pdf

If you have any problem on the templates, please contact aspdac2026 [at] aspdac.com.

All submissions must conform to the IEEE formatting guidelines and the instructions outlined on this page. Manuscripts that fail to meet these requirements are desk rejected without review.

2) Paper Submission

It is mandatory that at least one co-author per accepted paper registers the conference at the speaker's registration/full-time-student registration rate.
Please note that each paper shall be accompanied by at least one different full conference registration at the speaker/full-time-student rate (i.e., two speaker's registrations are needed for two accepted papers, e.g. from the main author or a co-author of a paper).

For more information, please contact: aspdac2026-udc [at] aspdac.com